![]() If you are working on both sides, and copying files in both directions, then you must use SmartTracking to detect and handle file deletions. you are copying only in one direction, then you can use Exact Mirror mode to synchronize deletions. If one side is always the “model” and the other side is always the “mirror”, i.e. You may also want to remove the last checkmark, “Enable Special Safety Warnings”, because these can prevent deletions from being carried out. To do so, please edit the profile in Advanced Mode, go to the Safety->Unattended tab sheet and make sure that deletions are enabled. Important note for all sync modes regarding deletions: if you want to run the profile in unattended mode, for example by running the scheduler, then you need to also give it explicit permission to delete the files. The post Running the scheduler as a service on Windows appeared first on Syncovery. You can even connect to a remote computer and control and watch the service running there. Even though the service is normally invisible, you can get a pretty good picture of what it’s currently doing or planning to do, using the Scheduler tab sheet of the main application window.Deleting to the recycle bin is not supported by the service.Rather than specifying the full path for the network connection, you can also try specifying just \\servername ![]() Use this setting on the Job tab sheet in the profile: Network Connections… However, in many cases this is not needed. If this is not sufficient, you can provide a username and password for the network resource in each profile.Also in order to enable access to a network drive, please try using a UNC path such as \\servername\sharename\foldername rather than a mapped drive letter.Windows Explorer should have already stored the password. ![]() Choose an account that has network access without Windows Explorer asking for a password for the network drive. Make sure that you specify a user account where you know that Windows Explorer has access to the volumes that you need. To change the log on account, please uninstall and then re-install the service. This is done when clicking on the Install… button on the Scheduler tab sheet to install the service.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |